02
Apr
THERE IS A CHIP IN THE KEY SWITCH TO START AND IS A MANUFACTURER NIGHTMARE WHICH IS THE MOST COMMON CAUSE. THERE IS A CHIP IN THE KEY SWITCH TO START AND IS A MANUFACTURER NIGHTMARE WHICH IS THE MOST COMMON CAUSE.
2004 pontiac grand am wont turn over 1 Answer.
Pontiac grand am wont start. While there are a variety of reasons your Pontiac Grand Am wont start the most common 3 are a dead battery an alternator problem or failed starter. 38 of the time its. The 2003 Pontiac Grand Am has 17 problems reported for engine wont turn over wont start.
Average repair cost is 900 at 89900 miles. Car complaints car problems and defect. Wont Start Cold Causes.
Far and away the number one reason that your Grand Am wont start in the cold is the battery. A battery has two different ratings cranking amps and cold cranking amps. Cold cranking amps are the batteries ability to start turn the engine over when it is cold.
2004 pontiac grand am wont turn over 1 Answer. My 2004 grand am ran fine this morning and when I went to start it a bit ago it wouldnt even attempt to start. Tried jumping it even though the battery is just a year and a half old.
Turn your key to on position for 10 minutes. Do not start the engine your security light should be blinking on and off and once it goes out turn your key to off for 10 seconds and back to on again to see if your security light blinking if not then turn your engine. Charge on low to maintain battery so it wont go dead will cause it to go back into theft mode and you will have to start all over again.
Remember dont crank engine during this processor you will have to start all over. You can text me any questions you may have 270-556-7357 Posted on Apr 09 2014. If all that is ok check for a stuck EGR then test fuel pump pressure If it wont restart determine whats missing the engine needs three things to run Spark at all plugs gas to all cylinders and compression in all cylinders tho an engine may run lacking one in one cylinder it wont run very well.
No Start Due to Failed Passlock Sensor on Pontiac Grand Am Problem Description The passlock sensor in the ignition lock cylinder may fail causing an anti-theft system fault and a no start condition. 2004 grand am wont start most of the time. 1 Answer 2004 Pontiac Grand Am Se 4 cylinder will not always start the car is used on a daily basis.
It may start it may not. The 2004 Pontiac Grand Am has 8 problems reported for engine wont turn over wont start. Average repair cost is 1200 at 135650 miles.
Car complaints car problems and. Check in the engine compartment fuse box it should be near the battery under the hood. The cover should be pretty easy to remove.
The fuel pump should be connected through a fuse in slot 48. If that fuse looks good then you may want to check the fuel pump relay also inside the engine. - 1999-2005 Pontiac Grand Am.
The Pontiac Grand Am is a mid-size car and later a compact car that was produced by PontiacThe Grand Am had two separate three-year runs in the 1970s. From 1973 to 1975 and again from 1978 to 1980. It was based on the GM A platformProduction of the Grand Am was canceled in 1980 when it was replaced by the Pontiac 6000The Grand Am was reintroduced in 1985 when it replaced the Pontiac Phoenix.
When you turn the key the password is sent to the body control module and if it matches the car will startif it doesnt it wont startI Im betting you need a new ignition cylinder and your problems will be solved. So does it just do that all of a sudden. 2004 grand am se v6 sometimes wont start unless gas pedal is pushed when you say -turn over do you mean firing-turning over to me means the starter motor is cranking or turning over-firing is when combustion happens in the cylinders-as far as the cranking continuing-try some wd40 in the ignition switch-it may be hanging up-Denny.
ONCE STARTED IF YOU CAN DONT TURN THE KEY CYLINDER TO OFF BUT ONLY TO THE START POSITION. YOUR DASH LIGHTS WILL REMAIN ON BUT THE CAR WILL SHUTOFF AND REMAIN IN POSITION TO START AGAIN WITHOUT PASS- LOCK HAPPENING. THERE IS A CHIP IN THE KEY SWITCH TO START AND IS A MANUFACTURER NIGHTMARE WHICH IS THE MOST COMMON CAUSE.
Your ignition has 4 positions 1Off 2ACC 3On 4Start Cranks over springs back to 3On Step 1 Attempt to start the vehicle this is the start position. It will crank and start for 1-2 seconds then stall. The security light will be on or flashing.